- Max. width: 225 mm
- Puller type: Wheel hub puller
- Hydraulical: No
Bahco pullers with two, three or four arms and inner bearing pullers
Bahco pullers remove gears, pulleys, hubs and bearings from a shaft without damaging the part or the shaft. They belong in the kit of maintenance technicians, car mechanics and machine builders who dismantle assemblies every day.
The number of arms decides how the puller grips. Two arms fit where there is little room around the workpiece, three arms spread the pulling force more evenly over a round part, and wheel pullers with three or four arms hold a hub at several points. For each puller, compare the arm span, which runs from 10 to 520 mm across the series, and the working depth to the spindle. When the bearing sits inside a housing, a ball bearing inner puller grips inside the bearing ring; choose it by the bearing's inner diameter.
Galvanised versions stand up better to rust in a damp workshop. These single pullers sit alongside sets and jacks in Bahco puller sets, wheel pullers and hydraulic jacks. When an arm or spindle wears out, replace just that part with Bahco spare arms and spindles for pullers and keep the puller itself in use.
- Max. height: 200 mm
- Hydraulical: No
- Number of hooks: 2
- Max. width: 200 mm
- Hydraulical: No
- Number of hooks: 3
- For diameter: 25-30 mm
- Max. height: 60 mm
- Max. width: 225 mm
- Puller type: Wheel hub puller
- Hydraulical: No
- Max. width: 70 mm
- Max. height: 65 mm
- Hydraulical: No
- Min. width: 55 mm
- Max. height: 210 mm
- Max. load: 4 t
- Max. width: 400 mm
- Hydraulical: No
- Number of hooks: 3
- Max. width: 350 mm
- Hydraulical: No
- Number of hooks: 3
- Max. width: 170 mm
- Hydraulical: No
- Number of hooks: 3
- For diameter: 40-75 mm
- Max. height: 100 mm
- Max. height: 200 mm
- Hydraulical: No
- Number of hooks: 2
- For diameter: 18-23 mm
- Max. height: 60 mm
- Max. width: 150 mm
- Hydraulical: No
- Number of hooks: 3
- Max. width: 70 mm
- Max. height: 65 mm
- Hydraulical: No
- For diameter: 7-9 mm
- Max. height: 30 mm
- Max. height: 100 mm
- Hydraulical: No
- Number of hooks: 2
- Max. height: 100 mm
- Hydraulical: No
- Number of hooks: 2
- Max. width: 40 mm
- Puller type: Ball joint puller
- Hydraulical: No
- Max. height: 100 mm
- Hydraulical: No
- Number of hooks: 2