SOUDAFIX VE400-SF is a two-component anchoring resin for the pressure-free securing of threaded rods (ETA: M8-M30), studs, reinforcement bars (ETA: Ø8-Ø32), threaded collars, profiles etc in various solid and hollow materials, such as cracked and uncracked concrete, solid brick, hollow brick, porous concrete, natural stone, plasterboard walls, etc
Characteristics:
Easy to use and to apply
Fast cure
Wide application area, even in wet drill holes, under water and at temp. as low as -10°C
Styrene free (low odour)
Cartridge re-usable by simply exchanging static mixer
Watertight and impermeable fixing
High chemical resistance
Fire Resistance class F120 (M8-M30)
European Technical Approval Option 1 for application in cracked and uncracked concrete
Emission in indoor air class A+
Applications:
Securing of heavy loads in solid and hollow building materials. Pressure free anchoring even close to edges. Can be used as repair mortar.
Directions for use:
Drill hole at recommended depth
Clean drillhole with brush and air pump thouroughly
Screw static mixer onto cartridge
Dispense the first 10 cm of the product to waste (on piece of
Cardboard) until an even colour (dark grey) is achieved, and the
Product is well mixed
Solid stone: fill the drill hole from bottom up.
Hollow brick: insert sleeve and fill it bottom up, so that the resin
Is pressed through the tiny holes of the sleeve
Insert anchoring rod with twisting left-right motion
Inspect the drill hole for adequate filling
Observe hardening time. Don't move the anchoring rod during curing
Leave the excess of product to cure as well.
Remove it mechanically with hammer and chisel once cured
Install component, applying the right torque
Remarks:
There is a risk of staining on porous substrates such as natural stone. On such substrates a preliminary compatibility test is recommended.
Key features according to our expert
Net volume: 380 ml
Principal hazard property: GHS07 Harmful or irritant
