Combo Pack Deals! Free Makita Battery⚡ Discover! Read more
Click for more items in this promotion! Read less
Choose your filter
Filter
Categories
Brand
Stocked items only
Price excl. VAT
to €
Overall length [mm]
Reach
Torque (max.) [Nm].
Torque range (min./max.) [Nm].
Overload protection
Graphic display
Torque (min.) [Nm].
Drive mounting, square [metric]
Drive intake, square [inch].
Drive square [metric]
Drive square [inch]

Buy a Gift Card

Gedore CAPTURE torque sensors and electronic testers, 0.1 to 1500 Nm

This category holds the Gedore CAPTURE sensors and electronic testers, used to measure and check tightening torques. They serve workshops, calibration and quality control wherever torque tools have to stay on a set value.

There are two lines. The CAPTURE LITE testers (CL) are self-contained measuring devices, with a capacity of 1, 10, 150 or 350 Nm. The CAPTURE sensors (CS) are separate transducers in a series of ranges, from 0.1 to 1.5 Nm on the smallest to 150 to 1500 Nm on the largest, with steps in between such as 2.5 to 25 Nm and 25 to 250 Nm.

Choose the range by the tool you are checking. A measurement is most accurate when the value falls in the middle of the range rather than at its low end, so a fine torque screwdriver calls for a small sensor and a large torque wrench for a sensor up to 500 or 1500 Nm. Workshops that manage a wide fleet of torque tools therefore combine several sensors. These devices belong to Gedore measuring and inspection technique, alongside the brand's other inspection instruments.

⚠️
Connection lost
Oops! It looks like you lost your connection. Page was automaticaly reload.