Replacement straps for strap and pipe wrenches
The strap is the only part of a strap wrench that really wears. It runs over the sharp edge of the head, is tensioned again with every pull, and takes oil, grease and sometimes solvent. Sooner or later it stretches or tears, and then the wrench slips on the workpiece. A replacement strap renews that part, so the handle and the mechanism stay in service.
Choose the strap on the wrench it has to fit. Length sets the largest diameter you can still wrap: short straps from around 425 mm for filters and small pipe, long straps up to 1200 mm for large lines and plastic pipe. Width and the way the end clamps into the head differ per manufacturer and are not interchangeable, so note the model of your wrench before ordering.
For plastic pipe there are separate straps that do not mark the surface. Other loose parts for wrenches sit under accessories and spare parts.
- Length: 930 mm
- Supplier warranty: FACOM - Legal warranty applicable
- Length: 500 mm
- For diameter: 65-105 mm
- Supplier warranty: FACOM - Legal warranty applicable
- For diameter: 65-110 mm
- Length: 300 mm
- For diameter: 165 mm
- Supplier warranty: FACOM - Legal warranty applicable
- For diameter: 100-155 mm
- Length: 300 mm
- For diameter: 145 mm
- Supplier warranty: FACOM - Legal warranty applicable
- For diameter: 66-106 mm
- Supplier warranty: FACOM - Legal warranty applicable
- Length: 950 mm
- Length: 900 mm
- Length: 490 mm