Product description
- Makes joints impervious to oil
- Grease and moisture
- Absolutely colourless
- Including pipette
HG wall and floor grout protector adheres to the cement joint and thus provides maximum, transparent protection against penetration of, for example, (edible) oil, grease and moisture. It also prevents limescale deposits. Many joints are porous and therefore easily absorb dirt, grease and moisture. Spilling wine, soft drinks or something greasy, for example, can cause stains that are difficult to remove. Dirty water can also penetrate the joints during cleaning, making them dirty and difficult to clean over time. Wall joints in damp rooms, such as the bathroom, can additionally be affected by mould and limescale. 250 ml is good for about 30 to 40 m² of joint area.
Instructions for use
- The joints must be clean and dry
- First clean your joints thoroughly with HG grout cleaner
- Rinse the joints with clean water and then allow the joints to dry thoroughly for 24 hours
- Allow new joints to harden completely and dry
- Floor joints in bathrooms and kitchens and frequently walked on floor joints (entrance/hallway):
- Apply HG wall and floor grout protector using the pipette provided
- Use 1 to 2 ml of liquid per metre of joint (0.5 cm wide)
- Joints wall surface (kitchen/sanitary):
- Apply HG wall and floor joint protector using a brush to the joints and leave to dry for 1 hour
- Then apply a second coat
- The product must be absorbed into the joint within 5 minutes
- If not, remove excess with a clean cloth
- After 36 to 48 hours the surface may be cleaned normally again
- For floor joints, the floor can be walked on after approx. 3 hours
- Floors in the shower can be used again after 8 hours
- Follow the instructions for use
- Over-application may cause yellowing of joints
- Consumption: 250 ml per 30-40 m² floor area (assuming 30 x 30 cm floor tiles and a joint of 0.5 cm)
