- Smallest diameter: 1 mm
- Quantity per set: 25
- Largest diameter: 13 mm
Facom ground drill sets, conical drill sets and spot weld drill sets
Facom drill sets keep drill bits together in a storage case, so every size is to hand in the workshop or the service van instead of hunting for loose bits. If you cut a thread after pre-drilling, Facom tap and die sets are in the category next door, within the wider Facom sets and kits group.
Sharpened drill sets are the basis for general drilling in metal. They come in several sizes: a 19-piece set covers the most used diameters, while a 25 or 50-piece set adds the in-between sizes needed for accurate fits. A bore set for riveting and tapping groups the diameters for the tapping hole and for rivets, so thread and riveted joint fit straight away.
For body repair there are small three-piece sets. A spot welding drill set drills out weld spots without damaging the panel below, and a conical drill set countersinks and deburrs holes. Pick the set that matches the work you do most often, and replace a worn bit with the same size so the set stays complete.
- Smallest diameter: 1 mm
- Drill set type: Metal drilling set
- Quantity per set: 19
- Smallest diameter: 1 mm
- Largest diameter: 10,5 mm
- Drill set type: Metal drilling set
- Smallest diameter: 1 mm
- Drill set type: Metal drilling set
- Quantity per set: 50
- Smallest diameter: 6 mm
- Drill set type: Metal drilling set
- Quantity per set: 3
- Smallest diameter: 3 mm
- Largest diameter: 30,5 mm
- Drill set type: Plate drill set