Non-standardised impregnated, pre-compressed foam tape for sealing joints and connections on the inside or as a backfill for exterior use. Ideal for installation of exterior joinery behind impact, if further sealed with e.g. Soudaseal 215 LM.
Properties:
Acoustic and thermal insulator
Dustproof
Windproof
Vapour-permeable
Meets requirements according to DIN4108 (EnEv) and RAL assembly recommendations
Easy to apply
Self-adhesive on one side (= mounting aid)
Causes no contamination of the joint edges
Neutral and odourless
Permanently elastic and paintable.
Applications:
As a joint finish in masonry, between precast elements and concrete walls. Soudaband Acryl 300 can also be used as secondary sealing of the joint between window frames and wall. Must be covered afterwards, e.g. with Soudaseal 215LM.
Instructions for use:
Soudaband Acryl 300 is easy to apply without special tools. The use of a spatula, knife or scissors and possibly wooden wedges is sufficient. After determining the joint width, select the corresponding tape size. The joint sides should be parallel and free of construction dirt and/or cement residue. When unrolling Souda tape, take at least 1 cm extra. In the case of vertical joints, start at the bottom by placing the Soudaband. Fix the swelling tape by pressing the self-adhesive side against a joint side using a putty knife. After application, the pre-compressed band will swell, causing it to press against the joint flanks, thus filling the joint, with any unevenness. When buttressing two Soudaband ends, it is important that they are flush on the visible side and that the two ends are firmly connected. Make sure there is an overlength per band and do not stretch it when installing.
